Center brace for the 2nd gen 1986-1992 RX-7. It replaces the center solid factory support. It is adjustable to allow the sub-frame to be tweaked to get a little more camber positive or negative from each rear wheel. These, unlike the rod end design offered elsewhere are solid supported at the chassis and sub-frame and do not twist and clunk. Powder coated black
Posted by Chad M on 30th Mar 2012
There are 4-5 different versions of this device available for correcting too much rear camber in the FC chassis. This is by far the most well thought out piece. The others clunk, or must be removed from the car to make adjustments to them.
We run this piece on an enduro car and street cars without issue.